Hyundai Veloster Manuals

Hyundai Veloster: Accelerator Position Sensor (APS). Specifications - Engine Control System - Fuel SystemHyundai Veloster: Accelerator Position Sensor (APS). Specifications

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Accelerator Position Sensor (APS). Specifications

Specification

Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.29 ~ 0.46
W.O.T
3.85 ~ 4.35
1.93 ~ 2.18


Accelerator Position Sensor (APS). Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important senso ...

Accelerator Position Sensor (APS). Schematic Diagrams
Circuit Diagram ...

See also:

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Categories


В© 2011-2024 Copyright www.hvmanual.com