Hyundai Veloster Manuals

Hyundai Veloster: Defroster - Features of your vehicleHyundai Veloster: Defroster

CAUTION

To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window.

✽ NOTICE

If you want to defrost and defog the front windshield, refer to “Windshield defrosting and defogging” in this section.

Rear window defroster

The defroster heats the window to remove frost, fog and thin ice from the rear

The defroster heats the window to remove frost, fog and thin ice from the rear window, while the engine is running. To activate the rear window defroster, press the rear window defroster button located in the center facia switch panel.

The indicator on the rear window defroster button illuminates when the defroster is ON.

If there is heavy accumulation of snow on the rear window, brush it off before operating the rear defroster.

The rear window defroster automatically turns off after approximately 20 minutes or when the ignition switch is turned off. To turn off the defroster, press the rear window defroster button again.

Outside rearview mirror defroster

If your vehicle is equipped with the outside rearview mirror defrosters, they will operate at the same time you turn on the rear window defroster.

Glove box lamp
The glove box lamp comes on when the glove box is opened. CAUTION To prevent unnecessary charging system drain, close the glove box securely after using the glove box. ...

Manual climate control system
1. A/C (Air conditioning) button 2. Air intake control button 3. Rear window defroster button 4. Mode selection button 5. Fan speed control knob 6. Temperature control knob 7. Front windshield d ...

See also:

Specifications
Specification Description Specification Ultrasonic sensor Rated voltage DC 12V Detecting range 11.8~47.2 i ...

Canister Close Valve (CCV). Description and Operation
Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmo ...

Components and Components Location
Components Location 1. Torsion beam axle 2. Shock absorber 3. Coil spring assembly ...

Categories


© 2011-2024 Copyright www.hvmanual.com