Hyundai Veloster Manuals

Hyundai Veloster: Front Repair procedures - Bumper - Body (Interior and Exterior)Hyundai Veloster: Front Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body (Interior and Exterior) / Bumper / Front Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover (A) mounting clips.
2.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
3.
Remove the front bumper lower mounting clips.
4.
Disconnect the fog lamp connector (A).
5.
Remove the front bumper.
6.
Installation is the reverse of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.

Front Components and Components Location
Components-1 1. Front bumper cover 2. Front bumper side bracket [LH] 3. Front bumper side bracket [RH] Components-2 (T-GDI) 1. Front b ...

Rear Components and Components Location
Components-1 1. Rear bumper cover 2. Tail trim lower cover 3. Rear bumper side bracket [RH] 4. Rear bumper side bracket [LH] Components-2 (T-GDI) ...

See also:

Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement. CAUTION To prevent damage to the wiper arms or other components, do not attempt to move th ...

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...

Seat Belt Buckle Switch (BS). Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat asse ...

Categories

© 2011-2026 Copyright www.hvmanual.com