Hyundai Veloster Manuals

Hyundai Veloster: Input Speed Sensor 2 > Description and Operation - Dual Clutch Transmission Control System - Dual Clutch Transmission(DCT) SystemHyundai Veloster: Input Speed Sensor 2 > Description and Operation

Description

The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the TCM. It provides important input information for electric control.
The information is needed in all operations, including feedback control, gear shift control and failure detection of other sensors.


Input Speed Sensor 1 > Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Remove the under cover. 2. Disconnect the inp ...

Input Speed Sensor 2 > Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Remove the under cover. 2. Disconnect the inp ...

See also:

Gear Actuator Motor > Repair procedures
Inspection 1. Turn off the ignition switch. 2. Disconnect the gear actuator motor connector. 3. Measure the ...

Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad& ...

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor conn ...

Categories


В© 2011-2025 Copyright www.hvmanual.com