Hyundai Veloster Manuals

Hyundai Veloster: Map lamp - Interior light - Features of your vehicleHyundai Veloster: Map lamp

Push the lens (1) to turn the map lamp on or off. This light produces a spot

Push the lens (1) to turn the map lamp on or off. This light produces a spot beam for convenient use as a map lamp at night or as a personal lamp for the driver and the front passenger.

• DOOR : In the DOOR position, the map lamp and the room lamp come on when any door is opened regardless of the ignition switch position.

When doors are unlocked by the transmitter (or smart key), the map lamp and the room lamp come on for approximately 30 seconds as long as any door is not open. The map lamp and the room lamp goes out gradually after approximately 30 seconds if the door is closed. However, if the ignition switch is ON or all doors are locked, the map lamp and the room lamp will turn off immediately. If a door is opened with the ignition switch in the ACC or LOCK position, the map lamp and the room lamp stay on for about 20 minutes. However, if a door is opened with the ignition switch in the ON position, the map lamp and the room lamp stay on continuously.

• ON : Map lamp and room lamp stay on at all times.

• OFF : The lights turn off even if a door is opened.

❈ When the lamp is turned ON by pressing the lens (1) the lamp does not turn off even if the switch (2) is in the OFF position.

Automatic turn off function
The interior lights automatically turn off approximately 20 minutes after the ignition switch is turned off. If your vehicle is equipped with the theft alarm system, the interior lights automatic ...

Room lamp
• ON (1): In the ON position, the light stays on at all times. • DOOR (2) : In the DOOR position, the light comes on when any door is opened regardless of the ignition switch position. When d ...

See also:

Good driving practices
Never take the vehicle out of gear and coast down a hill. This is extremely hazardous. Always leave the vehicle in gear. Do not "ride" the brakes. This can cause them to overheat and ...

Filler-Neck Assembly. Repair procedures
Removal 1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler ...

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

Categories


© 2011-2024 Copyright www.hvmanual.com