Hyundai Veloster: Measurement Point

Measurements should be taken at the center of the hole.

Measuring Actual Dimensions

1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

See also:

Clutch Release Cylinder. Repair procedures
Removal 1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing th ...

SRS Control Module (SRSCM). Components and Components Location
Components ...

Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace ...