Hyundai Veloster: Panoramaroof Switch. Repair procedures
Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Open the sunglass case cover from the overhead console then remove
the 2 screws holding the overhead console. Disconnect the switch connector
(6P) and then remove the overhead console lamp.
|
| 3. |
Check for continuity between the terminals. If the continuity
is not as specified, replace the sunroof switch
|
Schematic Diagrams
Panoramaroof Motor. Repair proceduresFuel Tank Pressure Sensor (FTPS). Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge ...
To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when you move the lever ...
Engine Control Module (ECM). Schematic Diagrams
Harness Connector
ECM Terminal Function
Connector [EGGM-A]
Pin No.
Description
Connected to
1
Injector (Cylinder #3) ...