Hyundai Veloster Manuals

Hyundai Veloster: Special Service Tools - General Information - Body (Interior and Exterior)Hyundai Veloster: Special Service Tools

Special Tools

Tool (Number and name)
Illustration
Use
09793-21000
Door hinge adjusting wrench

Adjustment, removal and installation of the door hinge
09800-21000
Ornament remover

Trim removal
09853-31000
Headliner clip remover

Headliner clip removal
09861-31100
Sealant cut-out tool

Cutting windshield sealant
(Use with 09861-31200)
09861-31200
Sealant cutting blade

Cutting windshield sealant
(Use with 09861-31100)
09861-31000
Windshield molding remover

Windshield molding removal
09880-4F000
Hog ring clip installer

Hog ring clip Installation
09816-2P100
Power silent cutting tool

Tool box for removing panoramaroof
09816-2P110
Air power tool

Air tool for installing blade
09816-2P121
Cutter-1

Blade for removing the front and side area of panoramaroof
(This blade has a inclination to progress upward.)
09816-2P122
Cutter-2

Blade for removing the front and side area of panoramaroof
(This blade has a inclination to progress upward.)
09816-2P123
Cutter-3

Blade for removing the front and side area of panoramaroof
(This blade has a inclination to progress downward.)
09816-2P124
Cutter-4

Blade for removing the front and side area of panoramaroof
(This blade has a inclination to push downward.)
09816-2P127
Cutter-7

Blade for removing the rear area of panoramaroof
09816-2P130
Cutter-10

Blade for removing the edge area of panoramaroof


Specifications
Specifications Items Specification Hood Type Rear hinged, front opening type Front Door Construction ...

Troubleshooting
Troubleshooting Symptom Suspect Area Remedy Water leaks from panoramaroof Deteriorated roof lid weatherstrip Replace ...

See also:

Side Airbag (SAB) Module. Repair procedures
Removal The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airba ...

Heated Oxygen Sensor (HO2S). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between th ...

Back-up Lamp Switch. Repair procedures
Inspection 1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup la ...

Categories


В© 2011-2024 Copyright www.hvmanual.com