WARNING - Windshield heating
Do not use the
or
position during cooling operation in
extremely humid weather. The difference between the temperature of the outside air
and that of the windshield could cause the outer surface of the windshield to fog
up, causing loss of visibility. In this case, set the mode selection knob or button
to the
position and fan speed control
knob or button to a lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot
position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set
the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window,
outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to
improve heater and defroster efficiency and to reduce the probability of fogging
up inside of the windshield.
The heating and cooling system can be controlled manually by pressing buttons
or turning knob(s) other than the AUTO button. In this case, the system works sequentially
according to the order of b ...
To defog inside windshield
1. Select any fan speed except “0” position. 2. Select desired temperature.
3. Select the or
position. 4. The outside (fresh)
air will be selected automaticall ...