Hyundai Veloster: Check Fuses

A blade type fuse test taps provided to allow checking the fuse itself without removing if from the fuse box. The fuse is good if the test lamp lights up when one lead is connected to the test taps (one at a time) and the other lead is grounded. (Turn the ignition switch so that the fuse circuit becomes operative)

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

Servicing The Electrical System

1. Prior to servicing the electrical system, be sure to turn off the ignition switch and disconnect the battery ground cable. ...

See also:

Specifications
Specification Item Bulb capacity(W) Lamp type Front Head lamp(High) 55 H7LL Head lamp(low) ...

Rear combination lamp. Repair procedures
Removal Rear Combination lamp 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after loosening 2 screws, an ...

ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output ...