Hyundai Veloster: Fuel Tank. Repair procedures
Removal
| 1. |
Release the residual pressure in fuel line (Refer to “Release
Residual Pressure in Fuel Line” in this group).
|
| 2. |
Remove the rear seat [LH] (Refer to “Seat” in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel pump connector (A).
|
| 5. |
Disconnect the fuel feed tube quick connector (B).
|
| 6. |
Disconnect the fuel tank pressure sensor connector (C).
|
| 7. |
Disconnect the vapor tube (D).
|
| 8. |
Lift the vehicle and support the fuel tank with a jack.
|
| 9. |
Remove the center muffler assembly (Refer to “Intake And Exhaust
System” in EM group).
|
| 10. |
Disconnect the fuel filler hose (A).
|
| 11. |
Remove the under cover (A) and the parking brake line installation
bolt (B).
|
| 12. |
Remove the fuel tank from the vehicle after removing the fuel
tank band (A).
|
Installation
| 1. |
Installation is reverse of removal.
|
Repair procedures
Fuel Pump. Repair proceduresCVVT Oil Control Valve (OCV). Specifications
Specification
Item
Specification
Coil Resistance (Ω)
6.9 ~ 7.9 [20°C(68°F)]
...
Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid sh ...
Wheel. Repair procedures
Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...