Hyundai Veloster Manuals

Hyundai Veloster: Immobilizer Control Unit. Repair procedures - Immobilizer System - Body Electrical SystemHyundai Veloster: Immobilizer Control Unit. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening the bolt.
[USA]

[CANADA]


Installation

1.
Install the immobilizer unit.
2.
Connector the immobilizer unit.
3.
Install the crash pad lower panel.

Repair procedures
Replacement Problems And Replacement Parts: Problem Part set Scan tool required? All keys have been lost Blank key (4) YES ...

Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad& ...

See also:

Front Wiper Motor. Repair procedures
Removal 1. Remove the passenger cowl top cover (A) to remove passenger wiper blade. 2. Loosen the windshield wiper arm nut (B) aft ...

Troubleshooting
Troubleshooting Ignition System Symptom Suspect area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch ...

System operation
Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed contr ...

Categories

В© 2011-2026 Copyright www.hvmanual.com