Hyundai Veloster Manuals

Hyundai Veloster: Knock Sensor (KS). Repair procedures - Engine Control System - Fuel SystemHyundai Veloster: Knock Sensor (KS). Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System� in EM group).
3.
Disconnect the injector connector (A).
4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.


Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.

Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)


Knock Sensor (KS). Schematic Diagrams
Circuit Diagram ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

See also:

Glove box lamp
The glove box lamp comes on when the glove box is opened. CAUTION To prevent unnecessary charging system drain, close the glove box securely after using the glove box. ...

Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ...

Clutch Master Cylinder. Components and Components Location
Components 1. Reverse hose 2. Master cylinder 3. Ignition lock switch 4. Clutch switch 5. Clutch arm assembly 6. Pedal pad ...

Categories

© 2011-2026 Copyright www.hvmanual.com