- Park your car at the side of the road so that you can work with the Tire
Mobility Kit away from moving traffic. Place your warning triangle in a prominent
place to make passing vehicles aware of your location.
- To be sure your vehicle will not move, even when you're on fairly level
ground, always set your parking brake.
- Only use the Tire Mobility Kit for sealing/inflation passenger car tires.
Do not use on motorcycles, bicycles or any other type of tires.
- Do not remove any foreign objects such as nails or screws that have penetrated
the tire.
- Before using the Tire Mobility Kit, read the precautionary advice printed
on the sealant bottle!
- Provided the car is outdoors, leave the engine running. Otherwise operating
the compressor may eventually drain the car battery.
- Never leave the Tire Mobility Kit unattended while it is being used.
- Do not leave the compressor running for more than 10 min. at a time or
it may overheat.
- Do not use the Tire Mobility Kit if the ambient temperature is below -22°F
(-30°C).
- Do not use the sealing compound after its expiration date which can be
found on the label of the bottle.
- Keep away from children.
CAUTION
The Tire Mobility Kit is a temporary fix to the tire and the tire should be
inspected by an authorized HYUNDAI dealer as soon as possible.
WARNING
• Have your tire repaired as soon as possible. The tire may loose air pressure
at any time after inflating with the TMK.
CAUTION
When using Tire Mobility Kit, the tire sealant can damage the tire pressure
sensor. After using the Tire Mobility Kit, have the tire pressure sensor checked
by an authorized HYUNDAI dealer.
With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture.
The system of compressor and sealing compound effectively and comfortably seals
most punctures in a passenger c ...
0. Speed restriction label 1. Sealant bottle and label with speed restriction
2. Filling hose from sealant bottle to wheel 3. Connectors and cable for the power
outlet direct connection 4. Holde ...
See also:
Turn Signal Lamp. Repair procedures
Removal
Door Mirror Turn Signal Lamp
1.
Disconnect the negative(-) battery terminal.
2.
Remove the mirror(A) from the mirror holder.
...
Filler-Neck Assembly. Repair procedures
Removal
1.
Open the fuel filler door, and then remove the filler-neck assembly
mounting screws (A).
2.
Disconnect the fuel filler ...
Auto Light Sensor. Repair procedures
Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto ligh ...