Inspection
Power seat motor |
1. |
Remove the seat and Lumbar support motor (A) connectors.
|
2. |
With the battery connected directly to the motor terminals, check
if the motors run smoothly.
|
3. |
Reverse the connections and check that the motor rotates in reverse.
|
4. |
If there is an abnormality, replace the motor.
|
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Purge Control Solenoid Valve (PCSV). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between th ...
SRS components and functions
The SRS consists of the following components:
1. Driver's front air bag module 2. Passenger's front air bag module 3. Side
impact air bag modules 4. Curtain air bag modules 5. Retractor p ...