Hyundai Veloster Manuals

Hyundai Veloster: Room Lamp. Repair procedures - Lighting System - Body Electrical SystemHyundai Veloster: Room Lamp. Repair procedures

Removal

Vanity Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the vanity lamp assembly after disconnecting the connector.

Tailgate Lamp
1.
Disconnect the tailgate lamp connector and remove the tailgate lamp (A).


Installation

Vanity Lamp
1.
Reconnect the vanity lamp connector.
2.
Install the vanity lamp.
Tailgate Lamp
1.
Reconnect the tailgate lamp connector and install the tailgate lamp.

Head Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to the BD group - "Front bumper") ...

Overhead Console Lamp. Repair procedures
Inspection 1. Remove the overhead console lamp (map lamp) assembly then check for continuity between terminals. If the continuity is not as specified, replace the map ...

See also:

Windshield washers (front)
In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and ...

Specifications
Specification Description Specification Ultrasonic sensor Rated voltage DC 12V Detecting range 11.8~47.2 i ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

Categories


В© 2011-2025 Copyright www.hvmanual.com