Hyundai Veloster: In case of an emergency while driving
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place.
If you have a flat tire while driving
If a tire goes flat while you are driving:
1.Take your foot off the accelerator pedal and let the car slow down while driving
straight ahead. Do not apply the brakes immediately or attempt to pull off the road
as this may cause a loss of control. When the car has slowed to such a speed that
it is safe to do so, brake carefully and pull off the road. Drive off the road as
far as possible and park on firm, level ground. If you are on a divided highway,
do not park in the median area between the two traffic lanes.
2.When the vehicle
is stopped, turn on your emergency hazard flashers, set the parking brake and put
the transaxle in P (automatic transaxle) or reverse (manual transaxle).
3.Have
all passengers get out of the car. Be sure they all get out on the side of the car
that is away from traffic.
4.When repairing a flat tire, follow the instruction
provided later in this section.
If engine stalls while driving
1. Reduce your speed gradually, keeping a straight line. Move cautiously off
the road to a safe place.
2. Turn on your emergency flashers.
3. Try to start
the engine again. If your vehicle will not start, contact an authorized HYUNDAI
dealer or seek other qualified assistance.
Road warning
If the engine will not startTroubleshooting
Troubleshooting
1.
The lamp switch inputs can be checked using the GDS.
2.
To check the input value of lamp switch, select option "IPM&quo ...
How vehicle audio works
AM and FM radio signals are broadcast from transmitter towers located around
your city. They are intercepted by the radio antenna on your vehicle. This signal
is then received by the radio and s ...
Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. To improve the
effectiveness of heating and cooling : - Heating:
- Cooling: 3. Set the temperature
control to the desired position. ...